视频输出端子

宇宙12345

谁知道ps2视频输出端子（约12孔）每个孔的定义？

黄埔校长

qq331

难道你想自己DIY？

adsl95

黄埔校长 发表于 2012-6-24 23:31

這網站有麼有PS2手柄和記憶卡接口的定義?
有的話麻煩提供一下,謝謝.

黄埔校长

adsl95 发表于 2012-6-25 10:54
這網站有麼有PS2手柄和記憶卡接口的定義?
有的話麻煩提供一下,謝謝.

手柄定义


记忆卡定义

记忆卡注解：
DATA

Signal from Card to PSX. This signal is an 8 bit serial transmission synchronous to the falling edge of clock (That is both the incoming and outgoing signals change on a high to low transition of clock. All the reading of signals is done on the leading edge to allow settling time.)

COMMAND

Signal from PSX to Card. This signal is the counter part of DATA. It is again an 8 bit serial transmission on the falling edge of clock.

VCC

VCC (heared to be) 3.6V. The main board in the PSX also has a surface mount 750mA fuse that will blow if you try to draw to much current through the plug (750mA is for both left, right and memory cards).

ATT

ATT is used to get the attention of the card. This signal will go low for the duration of a transmission.

CLOCK

Signal from PSX to card. Used to keep units in sync. 250KHz clock for PlayStation

ACK

Acknowledge signal from Card to PSX. This signal should go low for at least one clock period after each 8 bits are sent and ATT is still held low. If the ACK signal does not go low within about 60 us the PSX will then start interogating other devices.

宇宙12345

谢谢2楼解答！！！！！！！！！